Private Jet Joint; Stoner Guide

Private Jet Joint; Stoner Guide

To roll a Private Jet Joint, you’ll need the following supplies:

  • Transparent papers
  • regular rice papers
  • scissors
  • ravor
  • and of course herb

HOW-TO-ROLL-AN-AIRPLANE-JOINT

The first step of construction is to assemble the fuselage or the main part of the plane. This is to be rolled with the transparent papers. A skilled roller can roll it but I recommend molding the see-through papers around a pen that has the same shape as a plane fuselage. Transparent papers will slide right off the pen if they are fully dry.

image_1


 

Set the fuselage to the side for now, as the wings are next. You’ll need to roll two thin joints of equal length for the wings.

image_3


 

Stuff your mold with grinded herb and then put a filter/crutch into an end to keep the bud in place. The plane will be smoked from this filter once completed.

image_4


 

If the joint paper is made slightly moist you should be able to bend the joints slowly til they fit this shape.

image_6


 

Attach a layer of paper between the joints on one side. Then flip it over and fill the middle cavity with more herb.

image_7


 

Seal the cavity shut with another layer of paper and then make a slit in the middle where the wing will be attached to the fuselage.

image_8


 

The illusion of windows and a windshield can be made by cutting holes just like this on a sheet of rolling paper to be wrapped around the fuselage.

image_9


 

Use the scissors to make a corresponding slit on the fuselage where the wings will connect. This hole will allow airflow so the plane can be successfully smoked like a cross joint.

image_10


 

Attach the wings to the main body with another small piece of paper.

image_11


 

To make turbines for the rear of the plane I simply rolled a joint and cut small sections out to attach to the filter. The tail wing can be made using cardboard and can be slid into a small slit cut into the filter. Both the tail wing and turbines are for aesthetic value and don not change the function of the joint, infancy the tail wing should be removed before smoking.

image_12


 

Your Private Jet Joint is now complete and ready for take off! Enjoy ­čśÄ . Big thanks to @clairvoyager! Check him out on IG.

image_14

Private Jet Joint; Stoner Guide